Hi, I'm having problem installing FC3 on a PC with the following configuration: o ASUS A7N8X (non-deluxe) motherboard o Two Seagate HDs (200GB and 120GB) joined with LVM (there are a lot of Logical Volumes, but only one used for root file system. /boot is a separate partition. Tried installing on a plain partition too - crashed too.) I tried installing many times and anaconda kept crashing, with different reasons and at different stages of the installation. A lot of times, it crashed/hanged when formatting partitions. I installed Simply MEPIS on the system and "stress-test" it by opening up many applications and the system was stable. So, that reduced the possibility that there were hardware problems (defective memory chip or hard drives). Earlier, I installed FC3 on a low-end PC and I was able to complete the installation (even though anaconda crashed because, I think, it calculated the required disk space wrongly and simply crashed if it thought there wasn't enough disk space.) Any idea what can be the problem and more importantly, what is the workaround? I tried acpi=off switch already and it didn't help. (1) In Anaconda GUI installation, I got this error one time (a lot of times, I didn't get any error, just hang): /usr/lib/anaconda/iw/network.gui.py: 265: GtkWarning: file gtktable.c: line 515 (gtk_table_resize): assertion `n_rows > 0 && n_rows < 65536' failed devTable = gtk.Table(len(devopts),2) install exited abnormally. (2) Also in Anaconda GUI installation mode: *** glibc detected *** corrupted double-linked list 0x0c152610 *** install exited abnormally. (3) In Anaconda Text mode: Traceback(most recent call last): File "/usr/bin/anaconda", line 1165, in? intf.run(id,dispatch, configFileData) File "/usr/src/build/475960-i386/install//usr/lib/anaconda/text/py", line 477, in run exec.S File "<string>" line 1, in ? valueError: bad marshal data Any idea? Thanks much. -- Daniel.
