On Mon, 2004-11-29 at 00:47 -0600, Robert G. (Doc) Savage wrote: > On Fri, 2004-11-26 at 09:19 -0600, Robert G. (Doc) Savage wrote: > > Summary: > > > > IBM Thinkpad A22p with Cirrus Logic CS 4614/22/24 [CrystalClear > > SoundFusion Audio Accelerator] chip. Worked fine under FC1. After > > upgrading to FC3, I get no sound output at all from RealPlayer 8.0-1, or > > anything else. > > Adding to my original post... When I run System Settings -> Soundcard > Detection and click on the [ Play test sound ] bar, I can hear the test > sound, but _very_ faintly. > This is good. click the yes button on hearing the sound, then go to your mixer (alsamixer or aumix) and set the volumes. It then should work. Did for me. > When I run 'setup' from an Xterm command prompt and select 'Sound card > configuration', it runs sndconfig which promptly reports: > > --| ERROR: No Sound Modules found |-- > > You don't seem to be running a kernel with modular sound > enabled. (soundcore.o was not found in the module search path). > To use sndconfig, you must be running a kernel with modular > sound, such as the kernel shipped with Red Hat Linux or a 2.2 > or greater kernel. > > This is not surprising because soundcore.o is now named soundcore.ko. I > note that sndconfig says it's a tool for legacy sound cards. As such, > should it be replaced by a more up-to-date tool in 'setup'? > Don't run that one. the other sets it up properly. The gui is the correct tool to use. > -- Doc > Robert G. (Doc) Savage, BSE(EE), CISSP, RHCE | Fairview Heights, IL > Fedora Core 3 kernel 2.6.9-1.681_FC3 on a P-III/M IBM Thinkpad A22p > "Perfection is the enemy of good enough." > -- Admiral of the Fleet Sergei G. Gorshkov >
