Sounds like a good idea. How do I change the speed of the tape drive?
Thanks,
Jeremy
On Sep 10, 2004, at 1:12 PM, Hans Müller wrote:
C. Linus Hicks schrieb:
On Thu, 2004-09-09 at 14:27, Jeremy Conlin wrote:
I recently installed Fedora Core 2 on a Dell PowerEdge 2400 server
that previously ran Red Hat 9. The installation appears to proceed
normally. The problem is it never boots entirely. It hangs with
the following as the last message (after removing quiet mode):
Loading sd_mod.ko module
Loading aic7xxx.ko module
Are you saying the installer is hanging, or that the install completed
but now it won't boot the installed kernel?
try to reduce the spedd of the diveces in the controller bios. I have
the same problem with a tape drive. After set the speed from 160 to
80. it works.
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
