Hello List;
I have the above card and cannot get any sound under Linux.
I used "Linux Help - Corey's TvTuner Guide.html" to get the card to
work.
Now its showing video fine, the radio runes fine - but no sound from
either.
Both the TV and the radio work under WinXP - so the hardware is ok.
I have tries "xawtv" and "tvtime"
here is my /etc/modprobe.conf:
# i2c
alias char-major-89 i2c-dev
options i2c-core i2c_debug=1
options i2c-algo-bit bit_test=1
# bttv
alias char-major-81 videodev
alias char-major-81-0 bttv
options bttv card=13 radio=1 tuner=2 gbuffers=4
dmesg:
bttv: driver version 0.9.15 loaded
bttv: using 4 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
bttv0: Bt878 (rev 17) at 0000:01:08.0, irq: 11, latency: 32, mmio:
0xd8000000
bttv0: detected: Leadtek WinFast TV 2000 [card=34], PCI subsystem ID is
107d:6606
bttv0: using: AVerMedia TVCapture 98 [card=13,insmod option]
bttv0: gpio: en=00000000, out=00000000 in=00bf7707 [init]
bttv0: Hauppauge/Voodoo msp34xx: reset line init [11]
bttv0: Avermedia eeprom[0xffff]: tuner=Unknown type radio:yes remote
control:yes
bttv0: using tuner=2
bttv0: i2c: checking for MSP34xx @ 0x80... not found
bttv0: i2c: checking for MSP34xx (alternate address) @ 0x88... not
found
bttv0: i2c: checking for TDA9875 @ 0xb0... not found
bttv0: i2c: checking for TDA7432 @ 0x8a... not found
tvaudio: TV audio decoder + audio/video mux driver
tvaudio: known chips:
tda9840,tda9873h,tda9874h/a,tda9850,tda9855,tea6300,tea6420,tda8425,pic16c54
(PV951),ta8874z
tuner: chip found at addr 0xc2 i2c-bus bt878 #0 [sw]
tuner: type set to 2 (Philips NTSC (FI1236,FM1236 and compatibles)) by
bt878 #0 [sw]
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: registered device radio0
bttv0: PLL: 28636363 => 35468950 .. ok
bttv0: add subdevice "remote0"
bttv0: PLL can sleep, using XTAL (28636363).
lsmod:
Module Size Used by
tuner 18320 0
tvaudio 20492 0
bttv 143564 1
video_buf 17156 1 bttv
v4l2_common 5120 1 bttv
btcx_risc 3976 1 bttv
videodev 7424 2 bttv
loop 12936 2
snd_pcm_oss 49192 0
snd_mixer_oss 17536 1 snd_pcm_oss
snd_intel8x0 29960 1
snd_ac97_codec 65924 1 snd_intel8x0
snd_pcm 85000 2 snd_pcm_oss,snd_intel8x0
snd_timer 21252 1 snd_pcm
snd_page_alloc 9096 2 snd_intel8x0,snd_pcm
snd_mpu401_uart 6400 1 snd_intel8x0
snd_rawmidi 20516 1 snd_mpu401_uart
snd_seq_device 6664 1 snd_rawmidi
snd 46180 11
snd_pcm_oss,snd_mixer_oss,snd_intel8x0,snd_ac97_codec,snd_pcm,snd_timer,snd_mpu401_uart,snd_rawmidi,snd_seq_device
soundcore 7520 1 snd
sunrpc 130660 1
iptable_filter 2432 0
ip_tables 16256 1 iptable_filter
sg 33440 0
nls_iso8859_1 3968 2
ohci_hcd 18692 0
ehci_hcd 28164 0
aic7xxx 162104 0
sd_mod 17152 0
scsi_mod 104140 3 sg,aic7xxx,sd_mod
kernel:
2.6.8-rc2-Mick
I use KDE and have enabled all inputs/outputs and maxed all sliders in
kmix.
This TV card uses an external cable from line-out to soundcard line-in.
That is why I made sure that it worked under XP.
Any hints?
Thanks
Mick M.
=====
Dogs have Masters - Siamese Cats have Staff!
__________________________________
Do you Yahoo!?
New and Improved Yahoo! Mail - 100MB free storage!
http://promotions.yahoo.com/new_mail
