Hi, > > > I have a 3ware controller in a new server I just > > > received, and have installed FC1 on it. The > > controller > > > is detected but I can't find the devices hanging > > off > > > it at all. It's got 4 250gb PATA drives on the > > > controller. > > > > first you assign them to a unit in the 3ware > > controller's bios, hit alt-3 > > when the 3ware bios screen is up, (either a stripe > > of one kind or other, > > or jbod) then they show up as /dev/sd(a)(b)(c) > > That's where my problem is. I've assigned the 4 > 250's > under a raid 5 array within the 3ware, but when > booting into FC1 I don't see any /dev/sd? devices. > > Is there some way I can check the 3ware driver is > loaded properly? (I saw kudzu install support for it > on bootup). Ok, I see this in my dmesg output: Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 SCSI device sda: 1465185024 512-byte hdwr sectors (750175 MB) sda: sda1 3w-xxxx: Shutting down card 0. 3w-xxxx: Shutdown complete. scsi : 0 hosts left. So for some reason the kernel assigns sda1 to the 750gb raid 5, then shuts the controller down? Any ideas? Michael. Find local movie times and trailers on Yahoo! Movies. http://au.movies.yahoo.com
