Hi, We have installed FC1 on a new Dell P4 3Ghz pc. Everything runs well except that the scsi tape drive is not seen from fc1. When I boot the pc, the motherboard detects the scsi card and the scsi card detects the tape drive (this DDS4 is the only scsi device in this pc): AHA-2940UW v.2.11.0 ... SCSI ID: 2 SONY SDT-11000 Then, the fc1 starts booting and I don't see any information about it. After fc1 is started, I checked: # dmesg | grep scsi scsi0 : ata_piix scsi1 : ata_piix but, no output from: # dmesg | grep st0 # dmesg | grep st1 If I run: # /bin/mt -f /dev/st0 rewind /dev/st0: No such device I go to KDE -- Hardware Browser -- SCSI Devices, it shows: AHA 2940UW Pro/AIC-7888x but no device is displayed. I go to KDE -- Cotrol Center -- Information -- SCSI, it shows: "Attached devises: none" This tape drive was used in our another rh7.3 linux very well until I took it out from that system and installed in this fc1 a few days ago. The motherboard can see it, but fc1 can only see the scsi card, not the tape drive. Can somebody tell me why? how to fix the problem? Is there anything else I should do? Thanks a lot! Hongwei Li
