Hello, can anybody help me? [I was using FC1 and I could use my internal modem inside the IBM R40e-TP with the 2.9.5-SmartLink-driver [2.9.5] -> no problem(!).] After I installed the new system (FC2) on my R40e some problems has appeared: The new modem-driver (2.9.7 for 2.6-kernel) could be installed, but everytime one tries to load the driver the following output is created: > /usr/sbin/slmodemd > error: mdm setup: cannot open dev `/dev/slamr0': No such device > error: cannot setup device `/dev/slamr0' . This was strange to me since no problems came up while installing the driver. So I looked for debug-messages from my module (slamr): > #demesg > slamr: module license "Smart Link Ltd." taints kernel. > slamr: SmartLink AMRMO modem > slamr: device 10b9:5457 is grapped by driver serial: try to release > slamr: probe 10b9:5457 SL1800 card... > PCI: Found IRQ 11 for device 0000:00:03.0 > slamr: mc97 codec is 0 > slamr: cannot init card. I believe this error comes from that different driver module (serial) which is holding my modem resources. May you can help me with the configuration in order to get my modem working.../lib/module/2.6.5-.../build/driver/serial/... How can I fix this problem? Any hints? How can stop serial grapping my modem? THANX Konstantin -- "Sie haben neue Mails!" - Die GMX Toolbar informiert Sie beim Surfen! Jetzt aktivieren unter http://www.gmx.net/info
