----- Original Message -----
Sent: Tuesday, June 01, 2004 3:04
AM
Subject: Re: fc2 will not install to
sata
What kind of board do you have? I have a Gigabyte IPE8000PRO2 and
for
me FC2 loaded the ata_piix module and off it went!
Collen
Blijenberg <MLHJ> wrote:
Well, FC2 - sata DIDN'T work fine here..!!
(was an
amd64..)
rdc> Wrote FC2 to SATA fine here on an INTEL motherboard,
dont know about
AMD
rdc> --
rdc>
Reg.Clemens
rdc>
reg@xxxxxxxI have a Asus K8V standard 64
bit board, fc2 will not load to a serial ata
hard drive (maxtor 200gb) it
loads fine if I replace the sata hd with and
ide hd so the rest of the
hardware is ok.
Jeff
I think you'll find there's no sata driver - either ata or libata/scsi -
for your chipset. This is where having Fedora developers looking at the
list would be great.
Yes I agree, it definitely would seem as if
there is no support for the sata chipset on my board K8V, we can only hope
that one of the more experienced users and developers will see the post and
look into it.
Jeff
FC2 does not work on a ASUS K8V SE Deluxe MB either. It has a Promise
FastTrack 378 controller that is not even seen by FC2. Anybody have any
suggestions on how to get it to work?
