----- Original Message ----- From: "Karsten Hopp" <karsten@xxxxxxxxxx> To: "For users of Fedora Core releases" <fedora-list@xxxxxxxxxx> Sent: Friday, May 28, 2004 5:07 PM Subject: Re: fc2 will not install to sata > > > > > Hi sorry but I am totally lost, please hold my hand on this one :-) > > > > Ok I have the following connected > > > > PRIM IDE1 - none > > SEC IDE1 - none > > PRIM IDE2 - DVD RW > > SEC IDE2 - none > > > > Then just left of the floppy connector I have 2 serial ata connectors, SEC > > on top and PRIM just below it called SATA1 SATA2 > > > > Then below that I have 2 RAID serial ata connectors, called PRI_SATA and > > SEC_SATA, next to eack other, sec to left > > > > I have connected my sata hd to both SATA1 and PRI_SATA with same result, I > > have played with the bios settings, but am not sure what you mean by disable > > Promise RAID and set to IDE, I think I know how to disable the onboard > > Promise controller but how do I set it (what is "it") to IDE > > > > I have connected my two SATA drives to PRI_SATA and SEC_SATA and > have the following settings in my bios: > Advanced menu/OnChip SATA BOOTROM disabled > Advanced menu/OnBoard Promise Controller enabled > Advanced menu/OnBoard Promise Controller/Operating mode Onboard IDE operate mode > > Karsten > Ok I do not have that option in my bios, I have Advance menu/OnChip SATA BOOTROM - [Disabled] Advance menu/OnBoard Promise Controller -[Enabled] if enabled it then gives me Advance menu/Promise Boot ROM - [Enable or disable] There are no options for operating modes? Jeff
