On Mon, 2004-05-24 at 00:19, Jan Håkansson wrote: > sön 2004-05-23 klockan 17.32 skrev Chris Kloiber: > > On Sun, 2004-05-23 at 22:39, Jan Håkansson wrote: > > > Hi > > > > > > I have tried to change my settings on my NIC with ethtool. > > > I run "ethtool -s eth1 autoneg off" and "ethtool -s eth1 duplex full". > > > And it working perfect, but when I restart the computer the setting are > > > back to autoneg on and duplex half. > > > How can I save the settings. > > > > > > /Jan > > > > Add to /etc/sysconfig/network-scripts/ifcfg-eth1: > > > > ETHTOOL_OPTS="speed 100 duplex full autoneg off" > > > > Of course this should not be needed. If you set your switches port to > > auto-negotiation the network card will likely do the right thing. > > > > -- > > Chris Kloiber > > > > > Hi > > It work, but only if I set the speed to 10, when I try speed 100 the > network wont start. > Thanks. > > /Jan That tells me that you have to get the port on the switch set to auto-negotiate. I've seen this before and recently with a Intel e100 card and a Cisco switch that was forced to 100/full. The cards would not work correctly unless both the switch and the cards were allowed to negotiate. Gigabit cards are even pickier about it. -- Chris Kloiber
