I've just done a full install of FC2 (final) on a Tyan Tiger 230T (dual PIII 800) based system. I have an Intel E100 based ethernet card and a DLink 8139too based card. There's nothing very exotic beyond that. With the smp kernel, ethernet drivers load, the interfaces are configured, and routes look good, but I can't ping out at all (I can ping each interface). (That's with all firewalling loaded or flushed). Also, USB devices (mouse, cdrom, etc) are not detected and fail completely. The only thing that shows up are the 0000:0000 devices (hosts?). I had no problem with FC1 and smp, nor do I have these problems with FC2 and a UP kernel. Suggestions? -- Drew
Attachment:
signature.asc
Description: This is a digitally signed message part
