So your problem is ???????
bulent wrote:
Eric Diamond wrote:
Wednesday, April 07, 2004 3:57 AM Bülent Açy'kgöz
wrote:
Alexander Dalloz wrote:
Link detected: no
^^^^^
You see that? You have no link, thus you can not
successfully change
anything.
...snip...
Still no link! Check your cables. Check the other
side of the cable,
check the plug in the switch/hub/router or where it
is.
No I have link , Because I am downloading eveything
also
working samba and others.
Do you have any suggesstion?
Bülent,
Could you please post your 'ifconfig -a' output?
Eric Diamond
eDiamond Networking & Security
303-246-9555
eric@xxxxxxxxxxxx
Hello, ifconfig output like this;
[root@sbe-60 root]# ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:02:44:66:D3:32
inet addr:144.122.85.60 Bcast:144.122.85.255
Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:301403 errors:0 dropped:0 overruns:0 frame:0
TX packets:115798 errors:14 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:51269291 (48.8 Mb) TX bytes:119416712 (113.8 Mb)
Interrupt:11 Base address:0xec00
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:54794 errors:0 dropped:0 overruns:0 frame:0
TX packets:54794 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:101928795 (97.2 Mb) TX bytes:101928795 (97.2 Mb)
also,
root@sbe-60 root]# mii-tool eth0
eth0: 10 Mbit, half duplex, no link
[root@sbe-60 root]# ping 144.122.199.20
PING 144.122.199.20 (144.122.199.20) 56(84) bytes of data.
64 bytes from 144.122.199.20: icmp_seq=0 ttl=63 time=1.69 ms
64 bytes from 144.122.199.20: icmp_seq=1 ttl=63 time=1.39 ms
64 bytes from 144.122.199.20: icmp_seq=2 ttl=63 time=1.45 ms
64 bytes from 144.122.199.20: icmp_seq=3 ttl=63 time=1.27 ms
64 bytes from 144.122.199.20: icmp_seq=4 ttl=63 time=1.56 ms
64 bytes from 144.122.199.20: icmp_seq=5 ttl=63 time=1.50 ms
64 bytes from 144.122.199.20: icmp_seq=6 ttl=63 time=1.58 ms
Thank you...
