joeclifton@xxxxxxxxxxxxx wrote:
The following command should change your ethernet card to 100 MB/s and Full Duplex:
ethtool -s eth0 speed 100 duplex full
Hope this helps,
Joe
On Mon, 2004-04-05 at 09:36, bulent wrote:> Hello friends,> when I run mii-tool, I take this output;> > [root@sbe-60 root]# mii-tool> eth0: 10 Mbit, half duplex, no link> [root@sbe-60 root]#> > How can I change 100Mbit anf full duplex?> Thank you.......> > -- > Bülent Açy'kgöz> DBA & Sytem Administrator> > Mobile: +90 532 5639505> Work : +90 312 2103810> Adress: ODTU MM Binasi 3..Kat No:320 > Balgat/ANKARA/TURKIYE> > There is no crueler tyranny than that which is perpetrated under the shield of law and in the name of justice.>
Hello Joe,
I try your command but there is not any change;
[root@sbe-60 /]# ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: Not reported
Advertised auto-negotiation: No
Speed: 10Mb/s
Duplex: Half
Port: MII
PHYAD: 32
Transceiver: internal
Auto-negotiation: off
Current message level: 0x00000000 (0)
Link detected: no
[root@sbe-60 /]# ethtool -s eth0 speed 100 duplex full
[root@sbe-60 /]# ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: Not reported
Advertised auto-negotiation: No
Speed: 10Mb/s
Duplex: Half
Port: MII
PHYAD: 32
Transceiver: internal
Auto-negotiation: off
Current message level: 0x00000000 (0)
Link detected: no
[root@sbe-60 /]#Thank you.................
-- Bülent Açikgöz DBA & Sytem Administrator
Mobile: +90 532 5639505
Work : +90 312 2103810
Adress: ODTU MM Binasi 3.Kat No:320 Balgat/ANKARA/TURKIYE
There is no crueler tyranny than that which is perpetrated under the shield of law and in the name of justice.
