I might be totally wrong, but if you set up the RAID as hardware RAID, from the OS's point of view there is only one hard drive - so there is _no_ OS / software stuff to do. --> -----Original Message----- --> From: fedora-list-admin@xxxxxxxxxx --> [mailto:fedora-list-admin@xxxxxxxxxx]On Behalf Of Robert Hartung* --> Sent: Sunday, February 15, 2004 9:21 PM --> To: fedora-list@xxxxxxxxxx --> Subject: Raid 1 --> --> --> --> --> Hi all, --> I have a functioning FC1 with all updates. I have added a --> Belkin PC133 --> RAID/IDE hardware controller and went through their hardware --> setup to make a --> mirrored pair (for data use). --> --> These drives are seen as hde and hdg as reported by dmesg on --> boot. Now, I --> cannot find any documentation on how to get to disk druid after --> installation to --> make partitions and make them function as a RAID 1 device. I --> can't see any --> documentation re: fdisk that allows that utility to make a RAID 1 set. --> --> Where can I go to read and get this post-installation --> data-only RAID 1 setup? --> --> TIA --> --> Bob --> --> --> -- --> fedora-list mailing list --> fedora-list@xxxxxxxxxx --> To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list -->
