Mario Gomes (mgomes@xxxxxx) said: > I've installed Severn onto a Shuttle SK41G. Below are the specs for the > motherboard taken from the Shuttle website: > > FX41 > CPU Socket : AMD Socket A, support 266/200MHz FSB CPU > Chipsets : North bridge-VIA KM266, South bridge-VIA 8235 > Memory : Spoort DDR 266/200 * 2 > On Board VGA : VIA Savage8, 8-32 MB VGA share memory > On Board Audio : Realtek ALC650 support 5.1 channel audio, Support n/Out > Expansion Slot : PCI * 1, AGP * 1 > IDE interface : ATA-133 > > I was able to install Severn in text mode to the point that the computer > reboots. The problem arises when the reboot is processing, eventually > the screen goes blank and I get this error message: > > out of range > 26Hz / 21Khz > > I suspect that the monitor frequency is incorrectly set and I somehow > need to change this before the system starts loading. The monitor I > have is a GEM LCD and the frequency recommended is (H) 30Khz-60Khz and > (V) 50Hz-75 Hz. I would appreciate if someone has any suggestions on > how to correct this problem. If you boot with 'nogui', and then try to start X, is that when it goes out of spec? Bill
