I've installed Severn onto a Shuttle SK41G. Below are the specs for the motherboard taken from the Shuttle website: FX41 CPU Socket : AMD Socket A, support 266/200MHz FSB CPU Chipsets : North bridge-VIA KM266, South bridge-VIA 8235 Memory : Spoort DDR 266/200 * 2 On Board VGA : VIA Savage8, 8-32 MB VGA share memory On Board Audio : Realtek ALC650 support 5.1 channel audio, Support n/Out Expansion Slot : PCI * 1, AGP * 1 IDE interface : ATA-133 I was able to install Severn in text mode to the point that the computer reboots. The problem arises when the reboot is processing, eventually the screen goes blank and I get this error message: out of range 26Hz / 21Khz I suspect that the monitor frequency is incorrectly set and I somehow need to change this before the system starts loading. The monitor I have is a GEM LCD and the frequency recommended is (H) 30Khz-60Khz and (V) 50Hz-75 Hz. I would appreciate if someone has any suggestions on how to correct this problem. Thanks in advance. Mario
