Hi all, Well, I did what a few told me to do on here. I downloaded the ISO's and installed the OS from my hard drive, instead of via http or FTP. It worked! Well, kinda. If you remember, I couldn't get my network card to work to install off of the 'net: > class: NETWORK > bus: PCI > detached: 0 > device: eth > driver: unknown > desc: "3Com Corporation|unknown device 10b7:1700" > vendorId: 10b7 > deviceId: 1700 > subVendorId: 1043 > subDeviceId: 80eb > That board is a SysKonnect SK-98xx clone, the driver is *sk98lin* (Thanks, Xose!) So, installed off the hard drive. I go into redhat-config-networking and I delete the stupid card. Then, I try to reinstall it. Does fine until I try to activate it. Then...the message of doom in a box pops up: "3c501 devoice eth0 does not seem to be present, delaying initialization." OK gurus, what say you? ******************************************************************************* Gilbert Sebenste ******** (My opinions only!) ****** Staff Meteorologist, Northern Illinois University **** E-mail: gilbert@xxxxxxx *** web: http://weather.admin.niu.edu ** Work phone: 815-753-5492 * *******************************************************************************
