Am So, den 16.11.2003 schrieb Satish Balay um 15:40:
> > I just don't have a clue how to start that beast. Please, could someone
> > give some advice or a hint, where to find documentation?
> >
>
> 1. I think you'll have to use ath0 alias - not eth1 - as kudzu detected.
> 2. Because of this - redhat-config-network script doesn't work.
>
> So I modify /etc/modules.conf and have 'alias ath0 ath_pci' (instead
> of what kudzu added)
>
> And I just copy arround stuff - and create
> /etc/sysconfig/network-scripts/ifcfg-ath0 and
> /etc/sysconfig/network-scripts/keys-ath0 files - and start networking
> manually by using 'ifup ath0'
Hi,
thank you very much. I followed your instructions and things are going
much better now, but finally no success yet.
If a type ipup ath0
I get the following error message:
"Cannot get driver information: Operation not supported"
and then
Determining IP Information ..... (orig. German msg translated)
which will end unsuccessful.
ifconfig says:
ath0 Protokoll:Ethernet Hardware Adresse 00:05:4E:41:7D:62
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:254 errors:17 dropped:0 overruns:0 frame:17
TX packets:7 errors:0 dropped:0 overruns:0 carrier:0
Kollisionen:0 SendewarteschlangenlÃnge:199
RX bytes:27178 (26.5 Kb) TX bytes:328 (328.0 b)
Interrupt:11 Speicher:e4d67000-e4d77000
The Hardware Address is OK (according to the machines doc)
Any idea how to proceed or what to check further?
Thanks
Peter
