On Fri, 2003-11-14 at 14:34, J. Scott Amort wrote: > On Fri, 2003-11-14 at 08:51, Robert Marcano wrote: > > On Fri, 2003-11-14 at 12:36, Andy Green wrote: > > > Where did you put the modeline statement and what does it say? > > > > > Section "Monitor" > > Identifier "Monitor0" > > VendorName "Monitor Vendor" > > ModelName "IBM P70" > > DisplaySize 330 240 > > HorizSync 29.0 - 82.0 > > VertRefresh 50.0 - 120.0 > > Option "dpms" > > UseModes "P70Modes" > > EndSection > > > > Section "Modes" > > Identifier "P70Modes" > > Modeline "1152x870" 78.09 1152 1168 1384 1568 870 870 878 909 > > #Modeline "1152x870" 84.52 1152 1168 1384 1568 870 870 878 909 > > EndSection > > Make sure this modeline is also referenced in your screen section. Yes it is referenced there > > Section "Screen" > (other stuff...) > SubSection "Display" > Depth 24 (or whatever you have it set to) > Modes "1152x870" <-- make sure this is here > with whichever others you > may want to have available > EndSubSection > EndSection > > I believe X will default to the highest resolution in the Modes line, so > you may want to leave out anything higher than 1152x870, or else there > may be another step involved to set that one as your preferred > resolution. Good luck! > > Regards, > > Scott > > PS Check out the gtf command to determine the modeline for defining > different refresh rates for that resolution as well. > > > -- > fedora-list mailing list > fedora-list@xxxxxxxxxx > http://www.redhat.com/mailman/listinfo/fedora-list
