FC1 installer hangs when probing the adaptec scsi controller, from what I've read The errata kernel seems to have a 440GX routing fix but I don't know how I can use that to bootstrap an initial install
Anybody managed to get FC1 installed on a 440GX box
Yousuf -
The 400GX has been a bastard/broken chipset since it came out, particularly when associated with the various Adaptec drivers and cards - since RH-7.x.- or earlier, I've forgotten. Moreover, it depends upon the motherboard implementation of the chipset. I have several computers with this setup, and they all depend upon the BIOs capability! I haven't found one that supports acpi yet - the BIOs is too old.. Therefore, try the following - in this order - if your BIOs has the capabilty.
1.Make sure that your SCSI card is installed in the (FIRST) PCI slot. Remove all other cards if necessary.- although this is more like step 4.
2.Go into your computer BIOs setup and (if you can) set it so that the system recognizes pnp, turn off acpi and turn on apm. (the last two - under Power Managenent)
acpi = Advanced Configuration snd Power Interface
apm = Advsnced Power Management
Linux only can run one or the other, not both.
3. When you boot, when trying to install, go into "A" (append) and insert " acpi=off " but put it into the line BEFORE "rhgb" If you don't put it before 'rhgb' X86 may not run.
4. When all else fails - pull out all of your other cards from the mobo except the SCSI and try again.
There are a few more things that you can try - but I need more ifo on your system.
HTH
Bob Jones
