Re: questions about 8250 uart support for adhoc boards

[Rob Prowel <prowel@kuchera.com>]

Thanks so much for your followup.


Russell King wrote:
> On Fri, Feb 23, 2007 at 12:05:48PM -0500, Rob Prowel wrote:
>   
> > At least now, with fourport compiled into the kernel,
> >     
>
> You don't even need to do that.  Just configure SERIAL_8250_NR_UARTS
> and SERIAL_8250_RUNTIME_UARTS appropriately for your system.  There's
> absolutely no need to build any of the additional modules.
>
>   
Unfortunately what I'm seeing in 2.6.20.1 seems to differ from this.  If 
I use the options below:

CONFIG_SERIAL_8250=y
CONFIG_SERIAL_8250_CONSOLE=y
CONFIG_SERIAL_8250_PCI=y
CONFIG_SERIAL_8250_NR_UARTS=32
CONFIG_SERIAL_8250_RUNTIME_UARTS=16
CONFIG_SERIAL_8250_EXTENDED=y
CONFIG_SERIAL_8250_MANY_PORTS=y
# CONFIG_SERIAL_8250_FOURPORT is not set
# CONFIG_SERIAL_8250_ACCENT is not set
# CONFIG_SERIAL_8250_BOCA is not set
# CONFIG_SERIAL_8250_EXAR_ST16C554 is not set
# CONFIG_SERIAL_8250_HUB6 is not set
CONFIG_SERIAL_8250_SHARE_IRQ=y
CONFIG_SERIAL_8250_DETECT_IRQ=y
CONFIG_SERIAL_8250_RSA=y
# Non-8250 serial port support

Then I can only access ttyS0 through ttyS3 sith setserial.  Only after I add
CONFIG_SERIAL_8250_FOURPORT=y am I actually able to do anything with the 
additional ports.  I would otherwise get the evil setserial: invalid 
parameter error.

If you'd like I can offline you my complete .config file.  lemme know.

> > I can use 
> > setserial to see the uarts and correctly identify them...but the shared 
> > interrupt vector doesn't seem to work.  I haven't even attempted yet to 
> > try stty or echoing data our to an o-scope.
> >     
>
> I dropped support for the shared interrupt vector - having multiple
> different ISRs depending on the way the wind was blowing was extremely
> complex, and in this day and age of GHz CPUs rather silly.
>
> The serial driver can still share interrupts just fine.  Just omit
> configuring the multiport address and masks.
>
>   

OK.  Fair enough.  My question then becomes, how does the driver deal 
with this now? scan all applicable uarts when any relevant interrupt is 
detected (as identified in setserial)?


Thanks.



-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/