Re: 2.6.19-rc6-mm2

[Ed Tomlinson <edt@aei.ca>]

On Wednesday 29 November 2006 23:10, Randy Dunlap wrote:
> On Wed, 29 Nov 2006 22:42:20 -0500 Ed Tomlinson wrote:
> 
> > On Tuesday 28 November 2006 05:02, Andrew Morton wrote:
> > 
> > > Will appear eventually at
> > > 
> > > ftp://ftp.kernel.org/pub/linux/kernel/people/akpm/patches/2.6/2.6.19-rc6/2.6.19-rc6-mm2/
> > 
> > This kernel does not boot here.  It does not get far enough to post anything to my serial console.
> 
> Have you tried using "earlyprintk=..." to see if it produces any
> more output?

Nothing is displayed by earlyprintk.  I also added it to the rc5-mm2 boot to verify it.  The messages
displayed were the same as below...

Thanks
Ed
 
> > The last booted kernel here is 19-rc5-mm2.   Grub is used to boot, here is the starting log
> > of rc5-mm2 build is UP AMD64:
> > 
> > [    0.000000] Linux version 2.6.19-rc5-mm2 (root@grover) (gcc version 4.1.1 (Gentoo 4.1.1-r1)) #1 PREEM6
> > [    0.000000] Command line: root=/dev/sda3 vga=0x318 video=vesafb:ywrap,mtrr:3 console=tty0 console=tty1
> > [    0.000000] BIOS-provided physical RAM map:
> > [    0.000000]  BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
> > [    0.000000]  BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
> > [    0.000000]  BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
> > [    0.000000]  BIOS-e820: 0000000000100000 - 000000003fff0000 (usable)
> > [    0.000000]  BIOS-e820: 000000003fff0000 - 000000003fff3000 (ACPI NVS)
> > [    0.000000]  BIOS-e820: 000000003fff3000 - 0000000040000000 (ACPI data)
> > [    0.000000]  BIOS-e820: 00000000fec00000 - 00000000fec01000 (reserved)
> > [    0.000000]  BIOS-e820: 00000000fee00000 - 00000000fef00000 (reserved)
> > [    0.000000]  BIOS-e820: 00000000fefffc00 - 00000000ff000000 (reserved)
> > [    0.000000]  BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
> > [    0.000000] end_pfn_map = 1048576
> > [    0.000000] DMI 2.2 present.
> > [    0.000000] Zone PFN ranges:
> > [    0.000000]   DMA             0 ->     4096
> > [    0.000000]   DMA32        4096 ->  1048576
> > [    0.000000]   Normal    1048576 ->  1048576
> > [    0.000000] early_node_map[2] active PFN ranges
> > [    0.000000]     0:        0 ->      159
> > [    0.000000]     0:      256 ->   262128
> > [    0.000000] Nvidia board detected. Ignoring ACPI timer override.
> > [    0.000000] ACPI: PM-Timer IO Port: 0x4008
> > [    0.000000] ACPI: LAPIC (acpi_id[0x00] lapic_id[0x00] enabled)
> > [    0.000000] Processor #0 (Bootup-CPU)
> > [    0.000000] ACPI: LAPIC_NMI (acpi_id[0x00] high edge lint[0x1])
> > [    0.000000] ACPI: IOAPIC (id[0x02] address[0xfec00000] gsi_base[0])
> > [    0.000000] IOAPIC[0]: apic_id 2, address 0xfec00000, GSI 0-23
> > [    0.000000] ACPI: INT_SRC_OVR (bus 0 bus_irq 0 global_irq 2 dfl dfl)
> > [    0.000000] ACPI: BIOS IRQ0 pin2 override ignored.
> > [    0.000000] ACPI: INT_SRC_OVR (bus 0 bus_irq 9 global_irq 9 high level)
> > [    0.000000] ACPI: INT_SRC_OVR (bus 0 bus_irq 14 global_irq 14 high edge)
> > [    0.000000] ACPI: INT_SRC_OVR (bus 0 bus_irq 15 global_irq 15 high edge)
> > [    0.000000] Setting APIC routing to flat
> > [    0.000000] Using ACPI (MADT) for SMP configuration information
> > [    0.000000] Nosave address range: 000000000009f000 - 00000000000a0000
> > [    0.000000] Nosave address range: 00000000000a0000 - 00000000000f0000
> > [    0.000000] Nosave address range: 00000000000f0000 - 0000000000100000
> > [    0.000000] Allocating PCI resources starting at 50000000 (gap: 40000000:bec00000)
> > [    0.000000] Built 1 zonelists.  Total pages: 257320
> > [    0.000000] Kernel command line: root=/dev/sda3 vga=0x318 video=vesafb:ywrap,mtrr:3 console=tty0 cons1
> > [    0.000000] Initializing CPU#0
> > [    0.000000] PID hash table entries: 4096 (order: 12, 32768 bytes)
> > 
> > Any ideas what I should try or suggestions on patches to remove/try.
> > 
> > Thanks
> > Ed
> 
> ---
> ~Randy
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at  http://www.tux.org/lkml/
> 
> 
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/