Andrew,
I booted without the video and vga settings with earlyprintk=vga and got output. The
kenerl was complaining about a crc error. Checking the patch list I found:
crc32-replace-bitreverse-by-bitrev32.patch
reversing this patch fixes booting here.
Please do not push this on - it breaks amd64 here.
Thanks
Ed Tomlinson
On Thursday 30 November 2006 08:03, Ed Tomlinson wrote:
> On Wednesday 29 November 2006 23:10, Randy Dunlap wrote:
> > On Wed, 29 Nov 2006 22:42:20 -0500 Ed Tomlinson wrote:
> >
> > > On Tuesday 28 November 2006 05:02, Andrew Morton wrote:
> > >
> > > > Will appear eventually at
> > > >
> > > > ftp://ftp.kernel.org/pub/linux/kernel/people/akpm/patches/2.6/2.6.19-rc6/2.6.19-rc6-mm2/
> > >
> > > This kernel does not boot here. It does not get far enough to post anything to my serial console.
> >
> > Have you tried using "earlyprintk=..." to see if it produces any
> > more output?
>
> Nothing is displayed by earlyprintk. I also added it to the rc5-mm2 boot to verify it. The messages
> displayed were the same as below...
>
> Thanks
> Ed
>
> > > The last booted kernel here is 19-rc5-mm2. Grub is used to boot, here is the starting log
> > > of rc5-mm2 build is UP AMD64:
> > >
> > > [ 0.000000] Linux version 2.6.19-rc5-mm2 (root@grover) (gcc version 4.1.1 (Gentoo 4.1.1-r1)) #1 PREEM6
> > > [ 0.000000] Command line: root=/dev/sda3 vga=0x318 video=vesafb:ywrap,mtrr:3 console=tty0 console=tty1
> > > [ 0.000000] BIOS-provided physical RAM map:
> > > [ 0.000000] BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
> > > [ 0.000000] BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
> > > [ 0.000000] BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
> > > [ 0.000000] BIOS-e820: 0000000000100000 - 000000003fff0000 (usable)
> > > [ 0.000000] BIOS-e820: 000000003fff0000 - 000000003fff3000 (ACPI NVS)
> > > [ 0.000000] BIOS-e820: 000000003fff3000 - 0000000040000000 (ACPI data)
> > > [ 0.000000] BIOS-e820: 00000000fec00000 - 00000000fec01000 (reserved)
> > > [ 0.000000] BIOS-e820: 00000000fee00000 - 00000000fef00000 (reserved)
> > > [ 0.000000] BIOS-e820: 00000000fefffc00 - 00000000ff000000 (reserved)
> > > [ 0.000000] BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
> > > [ 0.000000] end_pfn_map = 1048576
> > > [ 0.000000] DMI 2.2 present.
> > > [ 0.000000] Zone PFN ranges:
> > > [ 0.000000] DMA 0 -> 4096
> > > [ 0.000000] DMA32 4096 -> 1048576
> > > [ 0.000000] Normal 1048576 -> 1048576
> > > [ 0.000000] early_node_map[2] active PFN ranges
> > > [ 0.000000] 0: 0 -> 159
> > > [ 0.000000] 0: 256 -> 262128
> > > [ 0.000000] Nvidia board detected. Ignoring ACPI timer override.
> > > [ 0.000000] ACPI: PM-Timer IO Port: 0x4008
> > > [ 0.000000] ACPI: LAPIC (acpi_id[0x00] lapic_id[0x00] enabled)
> > > [ 0.000000] Processor #0 (Bootup-CPU)
> > > [ 0.000000] ACPI: LAPIC_NMI (acpi_id[0x00] high edge lint[0x1])
> > > [ 0.000000] ACPI: IOAPIC (id[0x02] address[0xfec00000] gsi_base[0])
> > > [ 0.000000] IOAPIC[0]: apic_id 2, address 0xfec00000, GSI 0-23
> > > [ 0.000000] ACPI: INT_SRC_OVR (bus 0 bus_irq 0 global_irq 2 dfl dfl)
> > > [ 0.000000] ACPI: BIOS IRQ0 pin2 override ignored.
> > > [ 0.000000] ACPI: INT_SRC_OVR (bus 0 bus_irq 9 global_irq 9 high level)
> > > [ 0.000000] ACPI: INT_SRC_OVR (bus 0 bus_irq 14 global_irq 14 high edge)
> > > [ 0.000000] ACPI: INT_SRC_OVR (bus 0 bus_irq 15 global_irq 15 high edge)
> > > [ 0.000000] Setting APIC routing to flat
> > > [ 0.000000] Using ACPI (MADT) for SMP configuration information
> > > [ 0.000000] Nosave address range: 000000000009f000 - 00000000000a0000
> > > [ 0.000000] Nosave address range: 00000000000a0000 - 00000000000f0000
> > > [ 0.000000] Nosave address range: 00000000000f0000 - 0000000000100000
> > > [ 0.000000] Allocating PCI resources starting at 50000000 (gap: 40000000:bec00000)
> > > [ 0.000000] Built 1 zonelists. Total pages: 257320
> > > [ 0.000000] Kernel command line: root=/dev/sda3 vga=0x318 video=vesafb:ywrap,mtrr:3 console=tty0 cons1
> > > [ 0.000000] Initializing CPU#0
> > > [ 0.000000] PID hash table entries: 4096 (order: 12, 32768 bytes)
> > >
> > > Any ideas what I should try or suggestions on patches to remove/try.
> > >
> > > Thanks
> > > Ed
> >
> > ---
> > ~Randy
> > -
> > To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> > the body of a message to [email protected]
> > More majordomo info at http://vger.kernel.org/majordomo-info.html
> > Please read the FAQ at http://www.tux.org/lkml/
> >
> >
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to [email protected]
> More majordomo info at http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at http://www.tux.org/lkml/
>
>
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
