On 28 Sep 2006 10:54:04 +0200
Andrew Victor <[email protected]> wrote:
> hi Haavard,
>
> > Rename the following public definitions:
> > * AT91_NR_UART -> ATMEL_NR_UART
>
> Can you possible rather rename it to ATMEL_MAX_UART ?
>
> Since most AT91 board don't use all the UART's I've had a few reports
> of people trying to limit the number of UART's "detected" by changing
> this value - which of course can break things. (They should be
> changing the number of UARTs in their board-support files).
Sure. Here's an updated patch. This causes trivial rejects in a
couple of the other patches.
Haavard
From: Haavard Skinnemoen <[email protected]>
Subject: [PATCH] at91_serial -> atmel_serial: Public definitions
Rename the following public definitions:
* AT91_NR_UART -> ATMEL_MAX_UART
* struct at91_uart_data -> struct atmel_uart_data
* at91_default_console_device -> atmel_default_console_device
Signed-off-by: Haavard Skinnemoen <[email protected]>
---
arch/arm/mach-at91rm9200/devices.c | 22 +++++++++++-----------
arch/avr32/mach-at32ap/at32ap7000.c | 4 ++--
drivers/serial/atmel_serial.c | 14 +++++++-------
include/asm-arm/arch-at91rm9200/board.h | 4 ++--
include/asm-arm/arch-at91rm9200/hardware.h | 2 +-
include/asm-avr32/arch-at32ap/board.h | 4 ++--
6 files changed, 25 insertions(+), 25 deletions(-)
diff --git a/arch/arm/mach-at91rm9200/devices.c b/arch/arm/mach-at91rm9200/devices.c
index 78d6a1a..b8c0344 100644
--- a/arch/arm/mach-at91rm9200/devices.c
+++ b/arch/arm/mach-at91rm9200/devices.c
@@ -558,7 +558,7 @@ static struct resource dbgu_resources[]
},
};
-static struct at91_uart_data dbgu_data = {
+static struct atmel_uart_data dbgu_data = {
.use_dma_tx = 0,
.use_dma_rx = 0, /* DBGU not capable of receive DMA */
};
@@ -593,7 +593,7 @@ static struct resource uart0_resources[]
},
};
-static struct at91_uart_data uart0_data = {
+static struct atmel_uart_data uart0_data = {
.use_dma_tx = 1,
.use_dma_rx = 1,
};
@@ -635,7 +635,7 @@ static struct resource uart1_resources[]
},
};
-static struct at91_uart_data uart1_data = {
+static struct atmel_uart_data uart1_data = {
.use_dma_tx = 1,
.use_dma_rx = 1,
};
@@ -676,7 +676,7 @@ static struct resource uart2_resources[]
},
};
-static struct at91_uart_data uart2_data = {
+static struct atmel_uart_data uart2_data = {
.use_dma_tx = 1,
.use_dma_rx = 1,
};
@@ -711,7 +711,7 @@ static struct resource uart3_resources[]
},
};
-static struct at91_uart_data uart3_data = {
+static struct atmel_uart_data uart3_data = {
.use_dma_tx = 1,
.use_dma_rx = 1,
};
@@ -733,8 +733,8 @@ static inline void configure_usart3_pins
at91_set_B_periph(AT91_PIN_PA6, 0); /* RXD3 */
}
-struct platform_device *at91_uarts[AT91_NR_UART]; /* the UARTs to use */
-struct platform_device *at91_default_console_device; /* the serial console device */
+struct platform_device *at91_uarts[ATMEL_MAX_UART]; /* the UARTs to use */
+struct platform_device *atmel_default_console_device; /* the serial console device */
void __init at91_init_serial(struct at91_uart_config *config)
{
@@ -775,9 +775,9 @@ void __init at91_init_serial(struct at91
}
/* Set serial console device */
- if (config->console_tty < AT91_NR_UART)
- at91_default_console_device = at91_uarts[config->console_tty];
- if (!at91_default_console_device)
+ if (config->console_tty < ATMEL_MAX_UART)
+ atmel_default_console_device = at91_uarts[config->console_tty];
+ if (!atmel_default_console_device)
printk(KERN_INFO "AT91: No default serial console defined.\n");
}
@@ -785,7 +785,7 @@ void __init at91_add_device_serial(void)
{
int i;
- for (i = 0; i < AT91_NR_UART; i++) {
+ for (i = 0; i < ATMEL_MAX_UART; i++) {
if (at91_uarts[i])
platform_device_register(at91_uarts[i]);
}
diff --git a/arch/avr32/mach-at32ap/at32ap7000.c b/arch/avr32/mach-at32ap/at32ap7000.c
index aca7890..536bc88 100644
--- a/arch/avr32/mach-at32ap/at32ap7000.c
+++ b/arch/avr32/mach-at32ap/at32ap7000.c
@@ -615,11 +615,11 @@ struct platform_device *__init at32_add_
return pdev;
}
-struct platform_device *at91_default_console_device;
+struct platform_device *atmel_default_console_device;
void __init at32_setup_serial_console(unsigned int usart_id)
{
- at91_default_console_device = setup_usart(usart_id);
+ atmel_default_console_device = setup_usart(usart_id);
}
/* --------------------------------------------------------------------
diff --git a/drivers/serial/atmel_serial.c b/drivers/serial/atmel_serial.c
index b5f9e31..41cb844 100644
--- a/drivers/serial/atmel_serial.c
+++ b/drivers/serial/atmel_serial.c
@@ -113,7 +113,7 @@ struct at91_uart_port {
unsigned short suspended; /* is port suspended? */
};
-static struct at91_uart_port at91_ports[AT91_NR_UART];
+static struct at91_uart_port at91_ports[ATMEL_MAX_UART];
#ifdef SUPPORT_SYSRQ
static struct console at91_console;
@@ -682,7 +682,7 @@ static struct uart_ops at91_pops = {
static void __devinit at91_init_port(struct at91_uart_port *at91_port, struct platform_device *pdev)
{
struct uart_port *port = &at91_port->uart;
- struct at91_uart_data *data = pdev->dev.platform_data;
+ struct atmel_uart_data *data = pdev->dev.platform_data;
port->iotype = UPIO_MEM;
port->flags = UPF_BOOT_AUTOCONF;
@@ -834,9 +834,9 @@ #define AT91_CONSOLE_DEVICE &at91_consol
*/
static int __init at91_console_init(void)
{
- if (at91_default_console_device) {
- add_preferred_console(AT91_DEVICENAME, at91_default_console_device->id, NULL);
- at91_init_port(&(at91_ports[at91_default_console_device->id]), at91_default_console_device);
+ if (atmel_default_console_device) {
+ add_preferred_console(AT91_DEVICENAME, atmel_default_console_device->id, NULL);
+ at91_init_port(&(at91_ports[atmel_default_console_device->id]), atmel_default_console_device);
register_console(&at91_console);
}
@@ -849,7 +849,7 @@ console_initcall(at91_console_init);
*/
static int __init at91_late_console_init(void)
{
- if (at91_default_console_device && !(at91_console.flags & CON_ENABLED))
+ if (atmel_default_console_device && !(at91_console.flags & CON_ENABLED))
register_console(&at91_console);
return 0;
@@ -866,7 +866,7 @@ static struct uart_driver at91_uart = {
.dev_name = AT91_DEVICENAME,
.major = SERIAL_AT91_MAJOR,
.minor = MINOR_START,
- .nr = AT91_NR_UART,
+ .nr = ATMEL_MAX_UART,
.cons = AT91_CONSOLE_DEVICE,
};
diff --git a/include/asm-arm/arch-at91rm9200/board.h b/include/asm-arm/arch-at91rm9200/board.h
index c1ca9a4..d565270 100644
--- a/include/asm-arm/arch-at91rm9200/board.h
+++ b/include/asm-arm/arch-at91rm9200/board.h
@@ -97,10 +97,10 @@ struct at91_uart_config {
unsigned short nr_tty; /* number of serial tty's */
short tty_map[]; /* map UART to tty number */
};
-extern struct platform_device *at91_default_console_device;
+extern struct platform_device *atmel_default_console_device;
extern void __init at91_init_serial(struct at91_uart_config *config);
-struct at91_uart_data {
+struct atmel_uart_data {
short use_dma_tx; /* use transmit DMA? */
short use_dma_rx; /* use receive DMA? */
};
diff --git a/include/asm-arm/arch-at91rm9200/hardware.h b/include/asm-arm/arch-at91rm9200/hardware.h
index 235d39d..d1e607d 100644
--- a/include/asm-arm/arch-at91rm9200/hardware.h
+++ b/include/asm-arm/arch-at91rm9200/hardware.h
@@ -57,7 +57,7 @@ #define AT91_SRAM_SIZE 0x00004000 /* In
#define AT91_SRAM_VIRT_BASE (AT91_IO_VIRT_BASE - AT91_SRAM_SIZE)
/* Serial ports */
-#define AT91_NR_UART 5 /* 4 USART3's and one DBGU port */
+#define ATMEL_MAX_UART 5 /* 4 USART3's and one DBGU port */
/* FLASH */
#define AT91_FLASH_BASE 0x10000000 /* NCS0: Flash physical base address */
diff --git a/include/asm-avr32/arch-at32ap/board.h b/include/asm-avr32/arch-at32ap/board.h
index 39368e1..82e5404 100644
--- a/include/asm-avr32/arch-at32ap/board.h
+++ b/include/asm-avr32/arch-at32ap/board.h
@@ -9,8 +9,8 @@ #include <linux/types.h>
/* Add basic devices: system manager, interrupt controller, portmuxes, etc. */
void at32_add_system_devices(void);
-#define AT91_NR_UART 4
-extern struct platform_device *at91_default_console_device;
+#define ATMEL_MAX_UART 4
+extern struct platform_device *atmel_default_console_device;
struct platform_device *at32_add_device_usart(unsigned int id);
--
1.4.1.1
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
