Re: [PATCH 0/6] [RFC] Sizing zones and holes in an architecture independent manner

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



luck wrote:	[Tue Apr 11 2006, 06:20:29PM EDT]
> On Tue, Apr 11, 2006 at 11:39:46AM +0100, Mel Gorman wrote:
> 
> > The patches have only been *compile tested* for ia64 with a flatmem
> > configuration. At attempt was made to boot test on an ancient RS/6000
> > but the vanilla kernel does not boot so I have to investigate there.
> 
> The good news: Compilation is clean on the ia64 config variants that
> I usually build (all 10 of them).
> 
> The bad (or at least consistent) news: It doesn't boot on an Intel
> Tiger either (oops at kmem_cache_alloc+0x41).
> 
> -Tony
I had a reply queued to report the same failure with
DISCONTIG+NUMA+VIRTUAL_MEM_MAP.  This was 2 CPU HP rx2600. I'll take a closer 
look at the code tomorrow. 

bob
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

[Index of Archives]     [Kernel Newbies]     [Netfilter]     [Bugtraq]     [Photo]     [Stuff]     [Gimp]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Video 4 Linux]     [Linux for the blind]     [Linux Resources]
  Powered by Linux