Re: latest mtd changes broke collie

[Pavel Machek <pavel@ucw.cz>]

Hi!

> > Well, how do I found out? I tried switching to CFI, and it will not
> > boot (unable to mount root...). No mtd-related messages as far as I
> > can see. There's quite a lot of mtd-related config options, I set them
> > like this:
> 
> If the old sharp driver had even a _chance_ of working, then you
> presumably have four 8-bit flash chips laid out on a 32-bit bus, and
> those chips are compatible with the Intel command set.
> 
> You can CONFIG_MTD_JEDECPROBE, and you want CONFIG_MTD_MAP_BANK_WIDTH=4,
> CONFIG_MTD_CFI_I4, CONFIG_MTD_CFI_INTELEXT.
> 
> Check that your chips are listed in the table in jedec_probe.c and turn
> on all the debugging in jedec_probe.c 

Ok, I got a little bit more forward.

I created entry like this:
        {
                .mfr_id         = 0x00b0,
                .dev_id         = 0x00b0,
                .name           = "Collie hack",
                .uaddr          = {
                        [0] = MTD_UADDR_UNNECESSARY,    /* x8 */
                },
                .DevSize        = SIZE_4MiB,
                .CmdSet         = P_ID_INTEL_EXT,
                .NumEraseRegions= 1,
                .regions        = {
                        ERASEINFO(0x10000,8),
                }
}

(Which is probably wrong, I just made up the data), and set name in
collie.c to "jedec_probe". That made jedec_probe.c go alive, and it
prints...

Found: Collie hack
sa1100-0: Found 4 x8 devices at 0x0 in 32-bit bank
Sum of regions (200000) != total size of set of interleaved chips (1000000)
gen_probe: No Supported Vendor Command set found

sharp.c sets

			width = 4;
                        mtd->erasesize = 0x10000 * width / 2;
                        mtd->size = 0x800000 * width / 2;

...that is
		width = 4;
		erazesize = 0x20000;
		size      = 0x1000000;

Does it mean ERASEINFO(0x20000,7) should do the trick?

							Pavel
-- 
Thanks, Sharp!
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/