Re: [patch 2.6.13-rc3] sis190 driver

[Pascal CHAPPERON <pascal.chapperon@wanadoo.fr>]

> Message du 29/07/05 00:13
> De : "Francois Romieu" <romieu@fr.zoreil.com>
[...]
 
> Changes from previous version (20050722)
[...]
> o Minor round of mii/phy related changes. May crash.
> 
> Testing reports/review/patches are always appreciated.
> 

sis190-120 compiles, loads but does not work (sis190_init_phy() function).

# service network start
Bringing up loopback interface:                            [  OK  ]
Bringing up interface eth0:
Determining IP information for eth0... failed; no link present.  Check cable?
                                                           [FAILED]

#dmesg
sis190 Gigabit Ethernet driver 1.2 loaded.
ACPI: PCI Interrupt 0000:00:04.0[A] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
PCI: Setting latency timer of device 0000:00:04.0 to 64
0000:00:04.0: Read MAC address from APC.
eth0: Unknown PHY transceiver at address 1.
0000:00:04.0: sis190 at ffffc20000004c00 (IRQ: 11), 00:11:2f:e9:42:70
eth0: Enabling Auto-negotiation.

# ethtool eth0
Settings for eth0:
        Supported ports: [ TP MII ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
        Advertised auto-negotiation: Yes
        Speed: 100Mb/s
        Duplex: Full
        Port: MII
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: on
        Current message level: 0x00000037 (55)
        Link detected: no

I reverted to sis190-110, which works well on my box.

--
Pascal




-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/