Hi,
I recently installed FC4 on a brand
new P4 w/ dual internal 120GB HDD's. As part of the installation, I
used Anaconda to config the two drives identically in a RAID-1
arrangement. Before I fully use this system, I would like to practice a
bit with these new features:
1. What are the commands that Anaconda
actually ran? (Same question for LVM.)
2. What are the GUI and non-GUI
commands?
3. Suppose one disk has a problem, how do I
go about breaking the mirror w/o losing my logical boot volume?
4. How do I make changes to my RAID setup on
this system? (I.e., new drives, striping, etc.)
5. How do I setup clustering?
6. Where can I read up on how to admin an
FC4 box using RAID, LVM and Clustering?
As an aside, my installation had a minor
problem - during the post-install q+a session, the GUI didn't recognize my
mouse. Dunno why, but my KVM is connected via a 4-port IOGEAR KVM
switch. When I plugged in the mouse directly into the PC, everything
worked fine. Subsequently (after I finish the post-install q+a session,
and now during normal operations), the mouse via the KVM switch works
fine.
TIA,
Steve
