On 1/22/2011 12:03 PM, JB wrote:
> Kernel command line:
> always keep --> ignore_loglevel
> add --> enforcing=0
The only major difference this time is that it's also detecting the
additional drives that are on the add-on card. Previously it wasn't,
but now I can see them after it says 'waiting for hardware to
initialize...'. It's going through ata1.00, ata1.01, ata3.00, and
ata3.01 - which accounts for the four hard drives, and then it lists the
CD-ROM. But it still dies at the same exact spot after detecting the
CD-ROM ...
For the record, I previously tried without the add-on card plugged
in and it too went nowhere. So there is something either with the
CD-ROM or just after it that causing it to hang. And when I say hang,
I'm talking complete lock up. NUM key doesn't do anything, the machine
is a brick. Only recovery is to hold the power button till it shuts off.
By the way, when booting CentOS, it also displays that 'waiting for
hardware to initialize...' however it sits there for a mere 5 seconds
then moves on and boots normally.
--
users mailing list
users@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe or change subscription options:
https://admin.fedoraproject.org/mailman/listinfo/users
Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
