Hello,
In a X seesion I am unable to run in 1280x1024 will it works fine in
fc11.
00:02.0 VGA compatible controller: Intel Corporation 82Q963/Q965
Integrated
Graphics Controller (rev 02)
I was able to set the correct display by using xrandr with the options:
--newmode and -addmode
but is only works for the present session, then the mode that I
added is gone.
I tried to mode the mode in /etc/X11/xorg.conf, but it does not work
either.
It is probably due to the cancel out of the mode that I previously
created. I get: "could not apply the stored configuration for monitor"
In addition in fc14, there is not display setting ! is it a bug !
Thank.
--
---
==========================================================================
Patrick DUPRÉ | |
Department of Chemistry | | Phone: (44)-(0)-1904-434384
The University of York | | Fax: (44)-(0)-1904-432516
Heslington | |
York YO10 5DD United Kingdom | | email: patrick.dupre@xxxxxxxxxx
==========================================================================
--
users mailing list
users@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe or change subscription options:
https://admin.fedoraproject.org/mailman/listinfo/users
Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
