> Hi Steven, > > On Fri, May 28, 2010 at 16:59, Steven P. Ulrick > <lists-fedora@xxxxxxxxxxxx>wrote: > > > Hello Everyone, > > If the output of "/sbin/lspci | grep VGA" is: > > 03:00.0 VGA compatible controller: nVidia Corporation G94 [GeForce 9600 GT] > > (rev > > a1) > > > > are the correct instructions for installing the proprietary NVidia driver > > still > > located here: > > http://fedorasolved.org/video-solutions/nvidia-yum-kmod > > > > I have tried the above referenced instructions a couple of times, with the > > same, > > bad results... I am now going to try again, paying special attention to > > the > > "Troubleshooting" section... With this exact system, I have been so used > > to > > everything working (up until I installed Fedora 13) that I have never even > > had > > to look at the troubleshooting steps for these instructions before. > > > > I will get back to you with whatever happens. > > > > I have a 9800 GT, and all I had to do for F13 was enable rpmfusion repo and > install kmod-nvidia; after that Nvidia driver was already used on the next > boot, but it didn't recognize my dual-head setup (which was expected). I > tried using nvidia-settings (as root) to configure dual-head, but I had some > trouble setting it exactly the way I wanted; then I just replaced > /etc/X11/xorg.conf with the one from my F12 /etc backup and that was it. Well, I have one of those :) I think I will try all of this over AGAIN :) > Much easier than with F12 =) You had a hard time getting this to work with F12? For me, on this same system, it "Just Worked." Steven P. Ulrick -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
