Adel ESSAFI wrote: > Hi list > This is the first time I have to configure linux as router. > I have a single network card for which I gave to IPs > > eth0 Link encap:Ethernet HWaddr 00:11:5B:72:7F:D9 > inet addr:41.231.X.Y Bcast:41.255.255.255 Mask:255.255.255.0 > inet6 addr: fe80::211:5bff:fe72:7fd9/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:2595 errors:0 dropped:0 overruns:0 frame:0 > TX packets:2295 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:1876353 (1.7 MiB) TX bytes:328059 (320.3 KiB) > Interrupt:21 Base address:0x8000 > > eth0:1 Link encap:Ethernet HWaddr 00:11:5B:72:7F:D9 > inet addr:192.168.10.10 Bcast:192.168.10.255 Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > Interrupt:21 Base address:0x8000 > > > > > and this is the default route > > [root@routeur ~]# route > Kernel IP routing table > Destination Gateway Genmask Flags Metric Ref Use > Iface > 41.231.2.0 * 255.255.255.0 U 0 0 0 eth0 > 192.168.10.0 * 255.255.255.0 U 0 0 0 eth0 > link-local * 255.255.0.0 U 1002 0 0 eth0 > default 41.231.2.81 0.0.0.0 UG 0 0 0 eth0 > That looks alright. > The problem now, is when I configure a PC with an IP adress 192.168.10.X > and I put the gateway as 192.168.10.10, I do not succeed to ping any PC. How > can I route all the packages from eth0:1 to eth0?? This isn't making very much sense. What is the address of your gateway? If it is 41.231.2.81, then it makes no sense to move it to the 192.168.10 network. If you're trying to set up a local network with NAT forwarding, then there's more to do. Andrew. -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines