On 11/18/2009 05:38 PM, Bruno Wolff III wrote:
On Wed, Nov 18, 2009 at 13:54:39 -0700,
Greg Woods<woods@xxxxxxxx> wrote:
On Wed, 2009-11-18 at 14:28 -0600, Bruno Wolff III wrote:
You can probably make an xorg.conf file to get around this.
I don't think I have enough knowledge of xorg.conf internals to do this.
I may just have a go at an over-the-top install if this is my only
option.
Here is a sample config I did for an nVidia card. You may need to change
some stuff. You can use cvt to make new mode lines.
# Xorg configuration created by system-config-display
Section "ServerLayout"
Identifier "single head configuration"
Screen 0 "Screen0" 0 0
InputDevice "Keyboard0" "CoreKeyboard"
EndSection
Section "InputDevice"
# keyboard added by system-config-display
Identifier "Keyboard0"
Driver "kbd"
Option "XkbModel" "pc105+inet"
Option "XkbLayout" "us"
EndSection
Section "Monitor"
Identifier "Monitor0"
ModelName "NEC MultiSync LCD2010X"
HorizSync 31.0 - 80.0
VertRefresh 56.0 - 85.0
Modeline "1280x1024_70.00" 129.00 1280 1368 1504 1728 1024 1027 1034 1069 -hsync +vsync
Option "dpms"
EndSection
Section "Device"
Identifier "Videocard0"
Driver "nouveau"
EndSection
Section "Screen"
Identifier "Screen0"
Device "Videocard0"
Monitor "Monitor0"
DefaultDepth 24
SubSection "Display"
Viewport 0 0
Virtual 1280 1024
Depth 24
Modes "1280x1024_70.00"
EndSubSection
EndSection
What cvt command do you give to get modelines.
I've tried using cvt without results.
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
