Patrick O'Callaghan wrote:
Just a quick note to call people's attention to
http://marc-abramowitz.com/archives/2007/02/17/getting-good-performance-out-of-usb-hard-drives-in-linux/. This is a couple of years old but it worked like a charm for me.
Briefly, there's a kernel parameter
called /sys/block/sd[a,b,...]/device/max_sectors (for USB drives sda,
sdb etc.). This specifies the maximum size of a disk I/O operation for
USB storage devices in units of 512 bytes, the default value being 240,
i.e. 120KB (see http://www.linux-usb.org/FAQ.html#i5). The max_sectors
value can be changed doing "echo N > ..." as root, and can have a
dramatic effect on write performance for USB devices such as pendrives.
I tested this by writing over 2GB to a fresh VFAT filesystem on a 4GB
Kingston Data Traveller pendrive plugged into a USB2 port with the EHCI
driver (as indicated by dmesg). With the default setting, this took
nearly 90 minutes including a final sync to flush the buffers. Using a
max_sectors value of 1024 -- the highest the system would accept -- the
time was reduced to under 16 minutes, a better than 5 times speedup.
YMMV of course, as different brands of pendrive can have very different
performance characteristics.
This has been discussed in other groups, and the issue seems to be that a write
to flash time is described as a constant value plus a size dependent value, and
that by doing fewer and larger writes the penalty of the constant is less, since
it is incurred less often.
Note that the value resets to the default when you unplug the drive, so
you need to set it manually each time. I don't know if there's a way to
do this automatically, or change the default value permanently.
Sorry of everyone already knew this, but I found it so useful I just had
to share it :-)
I found that it made essentially no difference in read speed (4300k/s vs
4400k/s) so people should be sure they note that "write" is specified in the
above 1st paragraph, don't overlook it!
Didn't seem to do much for write speed on a USB connected hard drive, so the
significant benefit seems limited to write to flash. That's important, but for
many uses there are far more reads than writes.
HINT:I wish it were a standard feature of install to a flash drive. Manually
setting it during install is probably worth trying. Any FC11 developers reading
this? HINT!!
--
Bill Davidsen <davidsen@xxxxxxx>
"We have more to fear from the bungling of the incompetent than from
the machinations of the wicked." - from Slashdot
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
