Help: F11 anaconda doesn't see my hard drives

[Sam Varshavchik <mrsam@xxxxxxxxxxxxxxx>]

Anaconda is barfing when I try to upgrade my existing F10. The machine has 
an IDE drive that contains a single Windows partitions, and two SCSI drives, 
hanging off an Adaptec 29320 HBA, with F10 on both drives in a RAID-1 
configuration.

When Anaconda gets to the "checking storage" phase, it spins for a while, 
then proceeds immediately to do a new install.

The partitioning screen has only /dev/sda listed, which is the existing 
Windows partition. /dev/sdb and /dev/sdc, the two SCSI drives, are not 
shown. HOWEVER:

When I flip over to ALT-F2, "fdisk /dev/sdb" and "fdisk /dev/sdc" read the 
partition table of the two SCSI drives. So, what I have is:

1) The kernel sees the SCSI drives

2) On some other ALT-F screen I see all the soothing messages from the md 
subsystem concerning registering various md personalities.

However,

3) mdadm isn't running

4) Anaconda sees neither the softraid partitions, nor the actual underlying 
/dev/sd? devices at all.

WTF?

This is a 64 bit machine. I have another machine 32 bit machine with no 
IDE drives, two SCSI drives connected to an AIC-7902B, also in a RAID-1 
configuration, and I had no problems whatsoever upgrading that one to F11.

Attachment: pgpXIX8QxTuPT.pgp
Description: PGP signature

-- 
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines