On 06/04/2009 10:57 AM, suvayu ali wrote:
2009/6/2 Jim<mickeyboa@xxxxxxxxxxxxx>:
FC10/Kde
I'm trying to setup a Linksys WUSB54G and I get this error message
from DMESG.
usb 2-2: firmware: requesting l3886usb
usb 2-2: (p54usb) cannot find firmware (isl3886usb)
usb 2-2: firmware: requesting isl3890usb
p54usb: probe of 2-2:1.0 failed with error -2
usbcore: registered new interface driver p54usb
Jim,
I 'm just shooting in the dark here, but something worth a try would
be to put both 'isl3886usb' and 'isl3890usb' in /lib/firmware. After
all in the messages it says the kernel is asking for both the
firmwares. Just a thought.
I did give both firmware names as
'isl3886usb' and 'isl3890usb' as you suggested and I'm kind of convinced that the firmware is not right for this adapter.
The firmware I downloaded was for the 2.6.29 kernel, which is what I.m using.
The output of Dmesg is attached.
1. usb 1-2: New USB device found, idVendor=1915, idProduct=2234
2. usb 1-2: firmware: requesting isl3886usb
3. phy0: p54 detected a LM86 firmware
4. p54: rx_mtu reduced from 3240 to 2392
5. phy0: FW rev 2.13.24.0 - Softmac protocol 5.9
6. phy0: cryptographic accelerator WEP:YES, TKIP:YES, CCMP:YES
7. phy0: device does not respond!
8. p54usb: probe of 1-2:1.0 failed with error -16
9. usbcore: registered new interface driver p54usb
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines