> > I am still struggling with this f10 install. It appeared that the > NIC in eth0 was no good. I pulled it out and left the second card > which was/is eth1. > > It looks to me like that designation eth1 might be changed to eth0 > using ethtool but if so, I can't find the right command. > > I have used service-config-network to set it up as 192.168.1.10 and > eth1, network-scripts is set up for eth1. but no matter what I do a > ping to another computer yields "Network is unreachable." > > This is a wired connection. I've tried a different cat5 cable. > "ethtools eth1" looks ok compared to the other computers. Not sure > what I have missed but it would be simpler perhaps if I could > convince the NIC that it was eth0 instead of eth1 but I can't > determine how that is set. > > Any help appreciated. I am about at wits end. Actually, it's probably in your /etc/modprobe.conf file. -- Mike Burger http://www.bubbanfriends.org Visit the Dog Pound II BBS telnet://dogpound2.citadel.org or http://dogpound2.citadel.org To be notified of updates to the web site, visit: https://www.bubbanfriends.org/mailman/listinfo/site-update or send a blank email message to: site-update-subscribe@xxxxxxxxxxxxxxxxx -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
