I forgot to tell you that in menuconfig
<M> Prism54 USB Support (So it is enabled in Kernel)
On 06/01/2009 12:15 PM, Jim wrote:
On 05/31/2009 01:36 PM, Suvayu Ali wrote:
Jim wrote:
On 05/31/2009 02:21 AM, Paulo Cavalcanti wrote:
On Sat, May 30, 2009 at 10:47 PM, Jim <mickeyboa@xxxxxxxxxxxxx
<mailto:mickeyboa@xxxxxxxxxxxxx>> wrote:
FC10/Kde
I'm trying to setup a Linksys WUSB54G and I get this error message
from DMESG.
usb 2-2: firmware: requesting l3886usb
usb 2-2: (p54usb) cannot find firmware (isl3886usb)
usb 2-2: firmware: requesting isl3890usb
p54usb: probe of 2-2:1.0 failed with error -2
usbcore: registered new interface driver p54usb
I have googled isl3886USB and can't find the firmware, does anyone
know where this firmware
is.
I am pretty sure I used one of those on F8, and it worked out of
the box.
Anyway, take a look at
http://markmail.org/message/oqgtvzwxholc5dsl
which will take you to:
http://wireless.kernel.org/en/users/Drivers/p54
--
Paulo Roma Cavalcanti
LCG - UFRJ
I should have told you that I'm trying install on a X86_64 box.
I did install the 2.13.24.0.lm86(2).arm and it is in /lib/firmware,
it would not install in
/lib64/firmware.
I think I need to install the ndiswrapper for i386, I have
ndiswrapper.X86_64 installed.
The ndiswrapper.i386 doesn't show up in FC10 X86_64 fedora repo how
do I change the repo's to read the i386 files ?
I think you missed a crucial step. Although right now I am using a
D-Link USB wifi receiver, I did try a Linksys for a few days after I
had set it up for the D-Link, and it worked right out of the box. So
the procedure should be the same. Here is how I did it for the D-Link.
1. I put the firmware in /lib/firmware/
2. Renamed it to 'isl3890usb'
2. in /lib/modules/`uname -r`/build/ ran "make menuconfig" as root,
enabled the relevant kernel module. then did a "modprobe <driver>".
Here <driver> is p54.
I believe you missed the renaming the firmware part.
HTH
PS: I am on x86_64 too
$uname -r
2.6.27.24-170.2.68.fc10.x86_64
I did as you suggested, but I'm still having problems.
Do you know what this means?
p54usb: probe of 2-2:1.0 failed with error -110
Here is my dmesg and lsmod
Dmesg
usb 2-2: (p54usb) cannot find firmware (isl3886usb)
usb 2-2: firmware: requesting isl3890usb
phy0: p54 detected a LM86 firmware
p54: rx_mtu reduced from 3240 to 2392
phy0: FW rev 2.13.24.0 - Softmac protocol 5.9
phy0: cryptographic accelerator WEP:YES, TKIP:YES, CCMP:YES
p54usb: probe of 2-2:1.0 failed with error -110
usbcore: registered new interface driver p54usb
Modules that are loading
p54usb 14208 0
p54common 20452 1 p54usb
mac80211 194224 2 p54usb,p54common
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
