On Thu, 2009-02-05 at 16:39 -0800, Aldo Foot wrote: > On Thu, Feb 5, 2009 at 1:52 PM, Rick Bilonick <rab@xxxxxxxxxxxx> wrote: > > I installed F10 64-bit on a Dell quad computer without any problems. > > (The computer had been running F5.) I did a fresh install on a new hard > > drive. eth0 worked fine under F5. I can get a connection using ssh and > > IP addresses but I cannot get DNS to work, even though I'm using the > > same DNS addresses (which I can ping). When I use the gui and put in the > > netmask (255.255.255.0), the gui constantly overwrites it. To get any > > connection, I have to go into the eth0 config file and set the netmask. > > (The gui always replaces the netmask IP with either the computer's IP or > > gateway IP - don't remember which.) I can't get this working so I can do > > an update. > > > > Any idea on what is going wrong? > > > > Rick B. > > > > -- > > fedora-list mailing list > > fedora-list@xxxxxxxxxx > > To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list > > Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines > > > > WARNING: this action overwrites /etc/resolv.conf. > > In the ifcfg-eth0 put a line with the DNS info > > DNS1=xxxx.xxxx.xxxx.xxxx > > Then do 'service network restart' --this will put the DNS info into > the /etc/resolv.conf. Works form me in F10. > As an aside... I'm not running running NetworkManager. > > ~af > Thanks. I found out earlier today that the network daemon was not enabled. Enabling it allowed DNS to work. I'm updating the F10 install and hopefully that will fix the bug in the network gui. Rick B. -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
