On Thu, Feb 5, 2009 at 1:52 PM, Rick Bilonick <rab@xxxxxxxxxxxx> wrote:
I installed F10 64-bit on a Dell quad computer without any problems.
(The computer had been running F5.) I did a fresh install on a new hard
drive. eth0 worked fine under F5. I can get a connection using ssh and
IP addresses but I cannot get DNS to work, even though I'm using the
same DNS addresses (which I can ping). When I use the gui and put in the
netmask (255.255.255.0), the gui constantly overwrites it. To get any
connection, I have to go into the eth0 config file and set the netmask.
(The gui always replaces the netmask IP with either the computer's IP or
gateway IP - don't remember which.) I can't get this working so I can do
an update.
Any idea on what is going wrong?
Rick B.
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
-- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
