I tied setting up a software RAID1 during the install but I kept getting
an error saying that there was an existing partition on the second disk.
I checked with fdisk /dev/sdb and found that there were no partitions
that fdisk could see. I've never had this problem before.
Is there something that changed in the Fedora 9 install procedure where
RAID setups are concerned?
Jack
Aldo Foot wrote:
On Thu, Oct 23, 2008 at 12:01 PM, Craig White <craigwhite@xxxxxxxxxxx> wrote:
BIOS Raid1 ? on ASUS motherboard? sounds like fake raid and wouldn't be
supported...at least not without some tacky vendor supplied driver.
Perhaps you need to give us info on this BIOS RAID (lspci -v)
I have a SuperMicro mobo that allows me to setup a Raid1 config. But a driver
must be supplied during the OS installation so the OS can see and use the raid.
The raid card has its own firmware and bios. The raid card's BIOS can
be accessed
during POST by pressing some key combination.
~af
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
