Greetings;
In /etc/sysconfig/ifcfg-eth0 I have the line as in the subject, but I note
that bringing up eth0, at a fixed ipv4 address in the 192.168 block, there is
about a 5 second pause doing it, and ifconfig does report what looks like
valid ipv6 addresses for both eth0 and lo.
eth0 Link encap:Ethernet HWaddr 00:1F:C6:62:FC:BB
inet addr:192.168.71.3 Bcast:192.168.71.255 Mask:255.255.255.0
inet6 addr: fe80::21f:c6ff:fe62:fcbb/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:52899 errors:0 dropped:0 overruns:0 frame:0
TX packets:45100 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:34184438 (32.6 MiB) TX bytes:26737247 (25.4 MiB)
Interrupt:22 Base address:0xa000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:6888 errors:0 dropped:0 overruns:0 frame:0
TX packets:6888 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:16987249 (16.2 MiB) TX bytes:16987249 (16.2 MiB)
How does one go about disabling that?
--
Cheers, Gene
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
"Only a brain-damaged operating system would support task switching and not
make the simple next step of supporting multitasking."
-- George McFry
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
