On Fri, 2007-12-28 at 03:53 +0800, adrian kok wrote: > Hi all > > I am searching some sites and still don't know how to > setup the linux to send to console server > > Can you give me information? > > Thank you I read this How-To years ago (this site is an awesome resource BTW). http://tldp.org/HOWTO/Remote-Serial-Console-HOWTO/ The three things that need to be configured are: 1. BIOS (if you are lucky enough) 2. GRUB 3. kernel (through parameters from GRUB) For a quick and dirty answer: add (or modify) the following lines to /etc/grub.conf serial --unit=0 --speed=9600 --word=8 --parity=no --stop=1 terminal serial console and modify the "kernel" line in /etc/grub.conf adding console=tty0 console=ttyS0,9600n8 That will enable both GRUB and TTY access through ttyS0 (COM1 in win-speak) using 9600bps and 8n1. You can change those values, you just need to modify your serial terminal to match. --Tim ___________________________________________________ < Go on, EMOTE! I was RAISED on thought balloons!! > --------------------------------------------------- \ \ \ \ /\ ( ) .( o ).
