Greetings Fedora users.
I'm currently upgrading a machine from an oooold version of Fedora (core
3) to current. I'm up to FC4 at this point.
I have a I2O raid controller that was working fine in FC3 but for which
no module gets loaded at startup in FC4. Loading the i2o_block module
manually works though.
I don't need the module loaded in the initrd as this isn't for the root
partition, but I can't for the life of me remember how to load it during
startup (before my /data partition gets mounted obviously).
I suppose it's somewhere in modprobe.conf, but beside that...
In case it matters, here's the output from lspci -v for this card:
05:02.1 I2O: Adaptec (formerly DPT) SmartRAID V Controller (rev 02)
(prog-if 01)
Subsystem: Adaptec (formerly DPT) 2400A UDMA Four Channel
Flags: bus master, medium devsel, latency 64, IRQ 225
BIST result: 00
Memory at dc000000 (32-bit, prefetchable) [size=32M]
[virtual] Expansion ROM at dfb00000 [disabled] [size=32K]
Capabilities: [80] Power Management version 2
Any help would be much appreciated! :)
