I'd like to see them, thanks..
That was my initial problem. I loaded up the firmware, but did not
rebuild the initrd. Then I rebuilt my initrd and then pulled the new one
apart to verify that the firmware was in there, and it is. But I still
get the same behavior.
What is confusing me is when is the load being done? I see the nash
script in the initrd has the insmod command in it and the firmware is in
the initrd, but the firmware is not loaded. I don't actually need the
qla for the boot as I am booting off an ATA disk. I see what appears to
be a load of module in the dmesg with the error about not finding the
firmware, is this the message from the initrd sequence or some other
part of the boot up?
So after working on this all day yesterday....
1. Is the output from the initrd loading and therefor the nash init
script in the dmesg?
2. is the initrd the only place that would load this module, or is there
some script after the initrd hands off to init that also loads such
modules? Where might that be? I cannot find such a script.
3. what is the best way to go about traking this down - hack my initrd,
or mkinitrd?
4. did i miss a step on regenerating my initrd?
5. I can certainly add a rc.local script or the like, but I'd rather
this worked as intended, and I've rather been enjoying digging into
parts of linux that I don't normally get to do. This is quite a change
from adding users, and fixing permissions and such...
Thanks for your help
Bob
Mark Haney wrote:
Andrew Parker wrote:
On Nov 15, 2007 2:33 PM, Bob Kryger <bobk@xxxxxxxxx> wrote:
So, I have an F7 system w/ a QLA2310 HBA. Everything works OK, when
done
by hand.
But when I reboot, the kernel module is not getting loaded correctly,
the firmware not loaded, then the md not assembled and not mounted.
So I unload the module, reload the module (which loads the firmware),
assemble the md0, and mount by hand and it works.
Questions:
Why is the module load at boot time not loading the firmware?
Where is that module load done in the startup sequence?
How do I approach resolution correctly, avoiding hacking the startup?
did you rebuild your initrd? i seem to remember getting some
wierdness with our 2312 cards (on RHEL, not Fedora) like that
Yeah I had the exact same problem last week and rebuilding initrd
worked perfectly. I have the instructions that someone posted (and
whoever it was thank you!) I'll be glad to send them to you.
