Re: framebuffer fails in standard kernel

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Matthew Saltzman wrote:
On Wed, 2007-07-25 at 09:50 -0400, Bill Davidsen wrote:
Matthew Saltzman wrote:
On Tue, 2007-07-24 at 22:38 -0400, Bill Davidsen wrote:
I generally don't care about using framebuffers, and when I do I have been building a kernel from source with the framebuffer built in. However, in the last month, I've had three cases where I wanted to boot with a stock modular kernel and framebuffer, and it hasn't worked.

I have built a new initrd with the framebuffer and any needed modules added with "--preload" to get them in early. I have put video=<fb> information in the boot, and always the kernel boots, reads the boot options, and just goes away. Verified using intelfb, radeonfb, and atyfb, each with any needed drivers. But if I build these kernels from source, changing the default config only by building-in the same modules, it works fine.

The last time I tried this with a post-2.4 kernel, it worked, but that was a 2.5 kernel, and I haven't needed any video performance since.

Is this typical, should it just work, or ??? I have multiple systems to try, and all with work fine if I build in the exact same modules.
Not sure if this is your exact issue, but it may help anyway.

To get the FB module inserted whenever you install a distro kernel,
create /etc/sysconfig/mkinitrd with contents:

        MODULES="radeonfb"

Put any module options in /etc/modprobe.conf before rebuilding the
initrd.

I use the radeonfb on my Thinkpad to deal with a suspend power issue,
and those two steps work for me.

Thanks for the thought, I have the distro kernel installed, but I can set that and wait, or try to just do a mkinitrd. From the somewhat sparse docs it looks as if this does the same thing as using "--preload" which I was trying, but it certainly won't hurt to try again!

Once the options are in /etc/modprobe.conf, you can go ahead and remake
the current kernel's initrd.  In fact, I think if you
have /etc/sysconfig/mkinitrd set up, you don't even need to specify the
module when you mkinitrd by hand.  That's the implication here, anyway:

        http://www.ces.clemson.edu/linux/fc6_setup.shtml#radeon

Thanks for the useful link.

--
Bill Davidsen <davidsen@xxxxxxx>
  "We have more to fear from the bungling of the incompetent than from
the machinations of the wicked."  - from Slashdot


[Index of Archives]     [Current Fedora Users]     [Fedora Desktop]     [Fedora SELinux]     [Yosemite News]     [Yosemite Photos]     [KDE Users]     [Fedora Tools]     [Fedora Docs]

  Powered by Linux