I think you have identified at least part of my problem: ifconfig says that my workstation is 192.168.1.2. To match my router's settings, I need it to be 192.168.1.140. Can I just: ifconfig eth0 192.168.1.140 ? Thanks much! ----- Original Message ---- From: Jacques B. <jjrboucher@xxxxxxxxx> To: For users of Fedora <fedora-list@xxxxxxxxxx> Sent: Wednesday, June 27, 2007 4:45:54 AM Subject: Re: ssh - cannot log in On 6/27/07, David Katz <david@xxxxxxxxxxxxxxxxxxxxxxx> wrote: > I'm using Putty under XP to try to login to FC6 but it times out. > > I can ping the external ip from my laptop. > > Here's my iptables --list: > > Chain INPUT (policy ACCEPT) > target prot opt source destination > RH-Firewall-1-INPUT all -- anywhere anywhere > > Chain FORWARD (policy ACCEPT) > target prot opt source destination > RH-Firewall-1-INPUT all -- anywhere anywhere > > Chain OUTPUT (policy ACCEPT) > target prot opt source destination > > Chain RH-Firewall-1-INPUT (2 references) > target prot opt source destination > ACCEPT all -- anywhere anywhere > ACCEPT icmp -- anywhere anywhere icmp any > ACCEPT tcp -- anywhere anywhere tcp > dpt:http flags:SYN,RST,ACK/SYN > ACCEPT tcp -- anywhere anywhere tcp dpt:ssh > flags:SYN,RST,ACK/SYN > ACCEPT esp -- anywhere anywhere > ACCEPT ah -- anywhere anywhere > ACCEPT udp -- anywhere 224.0.0.251 udp dpt:mdns > ACCEPT udp -- anywhere anywhere udp dpt:ipp > ACCEPT tcp -- anywhere anywhere tcp dpt:ipp > ACCEPT all -- anywhere anywhere state > RELATED,ESTABLISHED > ACCEPT tcp -- anywhere anywhere state NEW > tcp dpt:xdmcp > ACCEPT udp -- anywhere anywhere state NEW > udp dpt:xdmcp > ACCEPT tcp -- anywhere anywhere state NEW > tcp dpt:x11 > ACCEPT tcp -- anywhere anywhere state NEW > tcp dpt:x11-ssh-offset > ACCEPT tcp -- anywhere anywhere state NEW > tcp dpt:ssh > REJECT all -- anywhere anywhere reject-with > icmp-host-prohibited > > I've tried without the windows firewall. The router is open to port 22 > and nats over to what I think is my workstation (how can I check this?) > > Thanks for any help. > > Note - ultimately I'd like to use X but right now I'm just trying to get > a login prompt. > > > > > -- > fedora-list mailing list > fedora-list@xxxxxxxxxx > To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list > Sounds like your router isn't forwarding port 22 traffic to your box from what you are describing. Check the settings on your router to see what IP it forwards port 22 traffic, and make sure your workstation has that IP (ifconfig command). You'll want to either statically set your IP on that workstation, or set up a static DHCP entry for the MAC of your workstation so it always gets the same IP. Otherwise your port forwarding destination IP will be a moving target. Having said all that, are you certain you are trying to connect to the proper public IP for your router? Have you checked what public IP is allocated to your router? Here again that is a moving target unless you have a static IP (very unlikely for a home user). So you may be trying to connect to an IP that is now allocated to someone else. Hence why the ping would respond but SSH would not work. If that is the case, you'll need to use a service such as DynDNS and enable that feature on your router (providing it supports it). Jacques B. -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
