|
Hello there,
I would like to have all ports open on eth-.
How would one go about this through system-config-securitylevel-tui? Here
is what my ifconfig reads.
eth0 Link
encap:Ethernet HWaddr
00:10:5A:98:7C:E9
UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) Interrupt:11 Base address:0xec00 eth1 Link encap:Ethernet HWaddr 00:06:5B:16:93:37 inet addr:192.168.1.100 Bcast:192.168.1.255 Mask:255.255.255.0 inet6 addr: fe80::206:5bff:fe16:9337/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:14499 errors:0 dropped:0 overruns:1 frame:0 TX packets:6139 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:5165422 (4.9 MiB) TX bytes:1712329 (1.6 MiB) Interrupt:11 Base address:0xc800 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:2284 errors:0 dropped:0 overruns:0 frame:0 TX packets:2284 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:3238776 (3.0 MiB) TX bytes:3238776 (3.0 Scott
|
