On Fri, 2007-05-04 at 23:54 +1000, Simon Slater wrote: > On Fri, 2007-05-04 at 07:52 -0500, Justin W wrote: > > > > > It looks like an selinux problem to me. Try relabling your directories > > to allow samba to access them. If you only need samba to access them, > > then the first line following will do, but if it needs to be shared with > > other services like apache or NFS, then the second group of following > > lines is what is needed. > > chcon -R -t samba_share_t /pub > > > > or > > > > setsebool -P allow_smbd_anon_write=1 > > chcon -R -t public_content_rw_t /pub > > > > I hope this helps you. > > > > Justin > > > Would toggling the checkbox for NFS shares under SELinux in > Administration->Security Level and Firewall do this? After verifying > what I had turned on to reply to Mike's post, I also checked this box. > Will wait a few minutes then try again to see if it made a difference. > Regards > Simon > Still could not access the /pub directory, but when printing a test page, I could see a job waiting in the print queue, even though the test page would not print with the message: Error writing to \\IPEX\LexmarkLaser for printer ... : Network name cannot be found. The printer is more important than the /pub share, would the same setsebool and chcon be appropriate? Regards Simon
