Em Segunda 15 Janeiro 2007 18:35, Robert Locke escreveu: > On Mon, 2007-01-15 at 12:58 -0300, Marcelo Magno T. Sales wrote: > > Hi, > > > > Em Sexta 12 Janeiro 2007 10:51, Robert Locke escreveu: > > > On Fri, 2007-01-12 at 10:07 +0200, Ian Brown wrote: > > > > Hello, > > > > > > > > I have a newly installer FC6 on x86_64, and when I run > > > > ifconfig -a I get at the bottom > > > > ... > > > > ... > > > > > > > > sit0 Link encap:IPv6-in-IPv4 > > > > NOARP MTU:1480 Metric:1 > > > > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > > > > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > > > > collisions:0 txqueuelen:0 > > > > RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) > > > > > > > > > > > > I have two questions regarding this: > > > > can I get rid of this sit0, so that in next boot it will not > > > > appear when I run "ifconfig -a" ? I don't use ipv6 (and will not > > > > use it until at least FC7 , but probably also not after FC7 is out). > > > > And I don't use ppp/slip on this machine (nor any special > > > > net features). > > > > > > > > Second: when I run "lsmod" I see : "ipv6" ; can I get rid of this > > > > module so that in next boot it will not appear ? (As said, I will > > > > **not** use ipv6 in the near future). > > > > > > > > Regards, > > > > Ian > > > > > > Ian, > > > > > > Add two lines to your /etc/modprobe.conf: > > > > > > alias ipv6 off > > > alias net-pf-10 off > > > > > > Then, after you reboot, both the sit0 and the ipv6 module will not > > > load... > > > > But what is this sit0 interface? > > Used when you want to take your IPv6 traffic and tunnel it through an > IPv4 cloud/network infrastructure. Apparently though the sit form of > tunneling is "deprecated" by the IPv6 people.... > > Take a look at: > http://www.bieringer.de/linux/IPv6/ > > for lots of great information on IPv6 on Linux.... > > --Rob
